The recommended torque you should apply to the screws is 5.0 to 6.0 lbf-in. (0.56 to 0.68 N-m). 3 Install the dock into the dashboard using the appropriate hardware (not included). 4 Attach the included bezel to the front of the dock. 5 If necessary, install all remaining dashboard components. Installing the Bracket on the Dock for IVECO ™ Vehicles 1 Place each bracket on the dock , aligning the holes on the bracket with the holes on the sides of the dock.
NOTICE Avoid wires, gauges, air bags, air bag covers, HVAC, and other items when cutting the dashboard and attaching the mount to the vehicle. Garmin is not responsible for any damages or consequences arising from the installation. 1 Place each bracket on the dock , aligning the holes in the bracket with the holes on the dock.
2 Using the included M5 screws , secure each bracket to the dock. You should apply a recommended torque of 5.0 to 6.0 lbf-in. (0.56 to 0.68 N-m) to the screws. 3 Remove the dashboard front panel. 4 Trim the mounting template, and confirm the device will fit in the mounting location. 5 Secure the template to the mounting location. 6 Using a jigsaw or rotary tool, cut the mounting surface along the dashed line on the template. 7 Place the device in the cutout to test the fit. 8 If necessary, refine the size of the cutout and remove extra material from the inside of the dashboard. 9 After the device fits correctly in the cutout, verify the mounting holes on the device line up with the pilot holes on the template. 10 If the mounting holes on the device do not line up, mark the new pilot-hole locations. 11 Using a 1.5 mm (#53) drill bit, drill the pilot holes. 12 Remove the template from the mounting surface. 13 Install the support bracket at the base of the cutout in the dashboard (not included). 14 Replace the dashboard front panel. 15 Connect all necessary cables to the device before placing it into the cutout. 16 Place the device into the cutout. 17 Secure the device to the mounting surface using the included M3 screws . 18 Install the decorative bezel by snapping it in place around the edges of the device. Installing the Device in a Dodge ProMaster 1 Place the upper bracket on the dock , aligning the holes in the bracket with the holes on the top of the dock.
2 Using the included screws , secure each bracket to the sides of the dock. The recommended torque you should apply to the screws is 5.0 to 6.0 lbf-in. (0.56 to 0.68 N-m). 3 Attach the bracket and dock to the dashboard using the appropriate hardware (not included). 4 Attach the included bezel to the front of the dock. 5 If necessary, install all remaining dashboard components. Installing the Bracket for FIAT ™ Ducato Vehicles 1 Place the upper bracket on the dock , aligning the holes in the bracket with the holes on the top of the dock.
2 Using the included screws , secure the bracket to the top of the dock. The recommended torque you should apply to the screws is 5.0 to 6.0 lbf-in. (0.56 to 0.68 N-m). 3 Repeat this procedure for the side brackets . 4 Install the upper and lower chassis brackets onto the dashboard. 5 Install the dock onto the dashboard using the appropriate hardware. 6 Attach the included bezel to the front of the dock. 7 If necessary, install all remaining dashboard components. Installing the Device in a Freightliner Cascadia You can use the included template and hardware to flush mount the device on the dashboard in your vehicle.
4
Powered by FlippingBook