6.9.3.6.4 Nonlinear You can enable or disable a nonlinear display of the angle. If the nonlinear setting is disabled, the line on the screen is plotted exactly at the (true) pitch or roll angle. Since it might be difficult to distinguish small angles, you can enable the nonlinear display of the angle. In this mode, the line is plotted at a greater angle if the true pitch or roll angle is small. While it is much easier to observe small angles and small changes in this mode, the angle of the line does not represent the true angle (it is exaggerated). 6.9.3.6.5 Calibration Used to calibrate the analog sensor. You can set voltage for zero point (angle 0°) and steps (millivolts per degree). 6.9.3.6.6 Display With this setting, you can show or hide the inclinometer on Caravan Panel’s screen. 6.9.3.6.7 Reverse If the inclinometer shows the inverse value for pitch or roll angle (e.g., left instead of right), you can enable this option to List of custom sensor that you have added to your Caravan Panel. By selecting a specific sensor, you can view or change its settings or delete it if necessary. By selecting “Add new”, you can add a custom user sensor. 6.9.3.7.1 Name Here, you can view or edit the the user sensor name. 6.9.3.7.2 Voltmeter Here, you can view and select a connected device, to which you have wired your custom device to. The custom device you want to select must be wired to a SC device with a voltage output (U1 or U2 ...). 6.9.3.7.3 Range MIN This option defines the minimum value of the sensor. Presented with a graphical representation (vertical bar), together with the current numerical value. This option defines the minimum value of the custom user sensor. reverse the display. 6.9.3.6.8 Delete With this option, you can delete the selected inclinometer sensor. 6.9.3.7 User Sensors
53
Powered by FlippingBook