Scotty AI Installation and Support Manual

Alternator temperature protection is active: The current indication is that the alternator is overheated, so you cannot use it now. • If the alternator's temperature is not high, there is a possibility that the temperature probe may have become disconnected. Therefore, we recommend checking the wiring to ensure it is properly connected. • Most Engines run around 90ºC under the engine bay, but some vehicles go as high as 105ºC. • We recommend increasing it to 120ºC in this case. HS Charge Voltage is reached: Based on current readings, the high-side battery voltage has reached the maximum allowable charge voltage. • To modify this setting, please access the designated 'Tuning page.' • However, we strongly advise referring to the battery manufac- turer's specifications before making any changes. An Error Occurred: We suggest checking for error messages, which may indicate that the HS or LS terminal is not adequately connected to the Battery. • To begin troubleshooting, we recommend inspecting the fuses and isolators and ensuring they function correctly. Voltage Sense Wire disconnected: The current indication suggests that the sense wire is not detecting sufficient voltage. • It may be due to a disconnected wire or a depleted starter battery. • If the cause of insufficient voltage is a depleted starter battery, it may not be possible to charge it via the current system. In this case, we recommend connecting an external charger to increase the starter battery voltage to an acceptable level. CAN Bus Signal Lost: The current indication suggests that the system may have lost its connection, as it requires a functioning CanBus system to operate even when not connected to a CAN Bus battery. • We recommend checking the CAN-H and CAN-L cables and performing a power cycle to resolve this issue. HS Battery is in Float Mode: • Based on current readings, it appears that the high-side battery float charge mode. To modify this setting, please access the designated 'setting page.' • However, we strongly advise referring to the battery manufac- turer's specifications before making any changes.