SCOTTY AI 3.0 TUNING GUIDE
g) Auto Tune
After all parameters have been set up. Turn on a engine.
And Click Auto Tune
Tuning process goes through 04 steps: Initiating Tuning State, Tuning Soft Stage, Tuning Medium Stage, Tuning Hard Stage.
You may would like to come back a Scotty Main Page to keep an eye on how much power Scotty charge from +LS to +HS buy click a link at the bottom of the Tunning page.
Below is a screenshot of Scotty while it is tuning at Medium Stage.
When tuning is successfully, you will se a message Dynamic Charging and Discharging
V. Scotty Advanced Page
You only need to access a Scotty advance page for setting up a master and slave Scotty. A master and slave set up is required when a system that have two Scotty working together with a single LS battery bank (two alternators is joined with a single battery bank). CAN connection between two Scotties is required for this set up.
Please contact us for IP address to access Scotty Advance Page.
Do not change any other parameters than the following parameters: Master , and Slave . Before seting a master and slave Scotty, you need to tune Scotty individualy as above procedure. After completing tune both Scotties individually, you need to access Scotty Advanced Page to set up a master and slave Scotty. For master Scotty: Enter number 10 into a Master and click Update
Please note keep a Slave as default. For slave Scotty: Enter number 10 into a Slave and click Update
Please note keep a Master as default.
8 17
WWW.SAFIERY.COM
Powered by FlippingBook