Scotty AI Installation and Support Manual

INSTALLATION

Have your High Side 24 V or 48 V (HS) batterie connected and the isolator applied so there is no power connection. Connect the 12 V Low Side and the ‘Enable Wire to 12 V Side’. A green flashing LED starts flashing. No Power will flow as no 24 V or 48 V battery is connected to HS. Open phone/tablet/laptop to WiFi > scan> connect to ‘Scotty XXXX’ SSID. The initial password is either 12345678 or on newer versions Scottyai@O (capital S). You can change the password later. Once connected, the ‘wheel connection indicator may still be turning’ as there is no internet. Go to the browser (we use Chrome) and type in: 172.24.24.1. Save this page to your home screen for future easy use. Check the values on the status page. You are ready to go. Just turn on the 24 V or 48 V battery on the HS to operate. Apply a voltage greater than 13 V and up to 125 A of current to the Low Side (LS), which will then charge a 24 V or 48 V battery on the High Side as a maximum of 60 A for a 24 V battery at 28 V, or 30 A for 48 V battery at 52 V. USB Bluetooth adapters that have been tested and known to work:

OPERATION

Soft’ puts the lowest load on the 12 V Power Supply.

Turn Scotty AI ‘Off’ and select ‘Soft’ for the lowest load setting.

Go to ‘Medium’ for first-time users who are unsure.

Go to ‘Hard’ to drive the maximum power from Low Side.

¡ ¡ ¢ ¢