Included in the box
The unit comes with a 1.5m long USB cable fix mounted. 1 pluggable terminal connector for external supply 4 pluggable terminal connectors for sensor connection
Mounting The enclosure can be wall mounted using the two flanges on the sides. Screws with an outer diameter of max 3.0mm should be used. The use of washers is recommended.
Connect and Release the Wires To physically attach the tank probes requires a ferrule or exposed copper end of at least 10 mm to be inserted into the removable terminal block connector. Once correctly attached, you must use the orange tab if you wish to remove the secured wire.
Cable shield It is recommended to use shielded cables to prevent interference to falsify the measurements. Most sensors are equipped with shielded cables. To get the best results the shield should be connected to bare metal of the vehicle or boat
Powered by FlippingBook