Safiery Solid State Lithium Battery
Data Communication ONLY on 48V 3C Discharge
Data Wiring Pinouts - There is an extra 4Pin Connector for Remote on/off and Stop Charge CAN cabling Connection is standard NMEA compliant cable Isolated with no power to CAN 120 Ohm Precision resistor inside Solid State Lithium Any Battery can be a “master” CAN connection is to Victron Cerbo VE.CAN. Set baud rate at 250baud
A “blue” Victron CAN plug may be required if this is the only CAN connection
Connection of multiple batteries
Remote On/Off/Reset and STOP Charge Connect a cable to the M5 Avaiation 4 Pin separate Outlet of the “Master” battery Pins 1 and 2 are the connections to close with free voltage contacts to remotely turn on Pins 3 and 4 are to drive a relay for “Stop Charge” and this includes the pre-alarm for discharge before the battery Mosfets open circuit as required in Marine regulations. Take M8 aviation cable and connect to the “out” of the master battery with the other end connect to the “In” of the second battery Repeat this process till all connected Press the “Reset/On” button at the Master Battery. It will come on and then the string of connected batteries follows If there is a fault in the string or a connection is not screwed in properly, the Master will flash a red light
4A
WWW.SAFIERY.COM
Powered by FlippingBook