CPE; -- CHARGE PROFILE ENTRY In response to RCP: command, this displays the current values of a Charge Profile Entry. Special note on Charge Profile Entries: All voltage and cu rrent values in Charge Profile tables are displayed in their normalized ‘12v’ val ues. See Defining Charging Voltages and Amps for additional information. “CPE;, n, ac ptVBAT, acptTIME, acptEXIT, res1, , ocAMPS, ocTIME, ocVBAT, ocAEXIT, , floatVBAT, floatAMPS, floatTIME, floatRESUMEA, floatRESUMEAH , floatRESUMEV, ,pfTIME, pfRESUME, pfRESUMEAH, , equalVBAT, equalAMPS, equalTIME, equalEXIT, , BatComp, CompMin, MinCharge, MaxCharge, ,RdcVolts, RdcLowTemp, RdcHighTemp, RdcAmps, ,floatSOC, ,MaxAmps, , pfVBAT, ”
n:
Charge Profile ‘n’ is being displayed/returned (1..8)
acptVBAT:
Target battery voltage during BULK and ACCEPT phase
acptTIME:
Time limit to stay in ACCEPT mode – in Minutes.
acptEXIT:
Amp limit to trigger exiting ACCEPT mode
res1:
Reserved for future use (dV/dT exit criteria, currently = 0, disabled)
ocAMPS:
Max Amps which will be supplied by during OVERCHARGE mode.
ocTIME:
Time limit to stay in OVERCHARGE mode – in Minutes.
ocVBAT:
Target battery voltage during OVERCHARGE phase
ocAEXIT:
Amp limit to trigger exiting OVERCHARGE mode
floatVBAT:
Target battery voltage during FLOAT phase
floatAMPS:
Max Amps which will be supplied by during FLOAT mode.
floatTIME:
Time limit to stay in FLOAT mode – in Minutes.
floatRESUMEA: Amp limit to trigger resumption of BULK charge mode
floatRESUMEAH: Amp Hours withdrawn after entering Float to trigger resumption of BULK charge mode
floatRESUMEV: Volt limit to trigger resumption of BULK charge mode
Note: If the regulator is in FORCED_FLOAT mode via the FEATURE-IN pin, then none of the above checks to exit float mode (e.g., floatTIME) will be performed. However, regulation will still occur to floatVBAT and floatAMPS .
20
Powered by FlippingBook