SST; -- SYSTEM STATUS “SST;, Version , ,Small Alt Mode?, Tach Mode?, , CP index, BC Mult, SysVolts, ,AltCap, CapRPMs, , Ahs, Whs, ,ForcedTM?”
Version:
Firmware revision identifier. Will have format of “AREG” followed w/o a space by the version number. E.g., “AREG1.0.1”
Small Alt?:
0 or 1, has the user selected Small Alternator Mode? (1 = yes)
Tach Mode?
0 or 1, has user selected Tach Mode? (1 = yes)
CP Index:
Which Charge profile (1..8) is currently being used?
BC Mult:
What adjustment factor for Battery Amp Hour Capacity (1-10x) is currently being used? Fractional values may also be used to fine tune the system to a given battery size. This needs to be entered via the $SCO: command.
SysVolt:
Detected system voltage. Adjusts target Charge Profile Volts per the following table:
Detected System Voltage
Charge Profile VOLTAGE Adjustment Factor
SysVolt
1
12v
1x
2
24v
2x
2.67
32v
2.667x
4
48v
4x
Fractional values may also be used to support battery voltages such as 8v, 32v, 42v. Those values will need to be selected manually via the $SCO: command.
Alt Cap:
If regulator is configured to auto-determine the capacity of the alternator, this will be the current high-water mark noted.
CapRPMs:
And this will be the RPMs at which that capacity was noted at.
AHs:
The number of Amp-Hours that have been produced in the current charge cycle.
WHs:
The number of Watt-Hours produced in the current charge cycle.
ForcedTM?:
0 or 1, has user forced Tach-Mode on via the $SCT: command.
25
Powered by FlippingBook