Aggregate BMS is an advanced capability, and it is up to the installer to test and assure the overall system responds in an expected way. Note that if enabled, Remote Voltage Sensing is disabled and the WS500 MUST be installed with the voltage sensing wires attached to an appropriate point in the battery bank. At present, the following BMS’s have been proofed with aggregated:
MG Energy BMS
Lithionics NeverDie TM BMS
A value of 0 (default) will disable any battery aggregation.
$CCN: will reply with “AOK;” if the command was processed successfully. However, to assure the changes are STORED and used the regulator must be reset using the $RBT: command after all changes have been made.
59
Powered by FlippingBook