Copyright Safiery Pty Ltd No Permission to Copy in any form without written permission
SMART SWITCHING LED LIGHTING ONLY
A: LED Lights ONLY with Black controller installed:
Background on wiring for Dimmable LED Lights.
Dimmable LED lights are dimmed by raising the 12V negative line to the light.
So each negative line MUST be independent. Do not ground to chassis or battery negative.
The 12V + line to LEDs may be a common line with a single fuse. This is done at output terminal R3-1, the 5 th pin from the left.
For LED Lighting circuits, relays are not engaged so check: • J1, J2, J3 are all pinned to 2-3 • J4, J5 are pinned to 1-2
• Fuse is placed in F5, if there is a fuse in F3 it is removed. R3-1 will be a common 12V+ for ALL LED Circuits • R1-2, R2-2. R3-2, R4-1 will be switch negative by the controller which can dim these circuits by direct control to 2A each
Easy Touch Switch inputs are wired using the RJ45 connector on I1, I2, I3 and I4 to and switch to GND (0V)
Switch Button Mapping to Wiring Positions (negative shown for LED lighting)
Terminal No for Switch Button - ALL LED Terminal 7: -ve 12V Terminal 6:-ve 12V
TOP LEFT BUTTON
TOP RIGHT BUTTON
Terminal 4:-ve 12V
Terminal 2:-ve 12V
BOTTOM LEFT BUTTON
BOTTOM RIGHT BUTTON
TRAVEL THE WORLD WITHOUT CONSUMING THE EARTH TM
Powered by FlippingBook